|
|
|
|
|
|
| RO System Series |
|
[Equipment overview]
The large and medium-sized RO series equipments produced by our company
are used for production of high purity water for industry sectors
including electricity,metallurgy,light industry,automobile,semiconductor,chemical,pharmaceutical,food
and medical treatment etc. Featuring compact structure, high quality
and low price, the system combines the most advanced RO membrane,
high-efficiency and low-noise high-pressure pump and instruments with
accurate measurement together into one independent system, which is
assembled on one independent support frame and the support frame is
also installed with one control panel. The whole RO system is under
the control of an advanced PLC system for control of start/stop of
the high-pressure pump, automatic protection for high and low pressure
and automatic rapid washing of the system etc.
The outlet water capacity of the RO system ranges from 0.5m3/h to
1000m3/h. The RO pressure vessel is made of stainless steel or FRP
material and low-pressure composite membrane is used as the RO membrane
with desalination rate of 99%; The operating pressure ranges between
1.3-2.0 Mpa, which depends on the water temperature and water quality.
[Technical performance]
The low-pressure switch will protect the high-pressure pump from being
damaged due to cutoff of water supply.
The use of high-efficiency and low-noise high-pressure pump can efficiently
reduce the operation noise and bring down the power consumption.
The roll type composite membrane with high desalination rate and low
operating pressure greatly improves the product water quality, reduce
the operating cost and extend the service life.
Flow meters are furnished on both product water pipe and concentrated
water pipe for monitoring and adjustment of the outlet water capacity
and the recovery rate.
The conductivity meter for product water is capable of continuous
monitoring of the product water quality.
The water inlet and drainage pressure gauges are used for continuous
monitoring of the pressure difference of the RO membrane to indicate
the time for backwashing.
The automatic water cutoff valve may prevent the water from flowing
in continuously during shutdown time.
The rapid rinse valve is used for periodic flushing of the membrane
surface to reduce the pollution.
[Applicable scope]
Electric industry
Electronic industry
Pharmaceutical industry
Bottled drinking water
Beverage industry
Metallurgy industry
Chemical industry
Dual water supply in residential areas
|
|
|
